Cake POP.....

FROSTY THE SNOW MAN CAKE POP
I made these  FROSTY THE SNOW MAN CAKE POP  is for  last year Christmas Party . I think they are very pretty and cute. 

I'm using the chocolate candy wafers and marshmallow to do the Hat.
The noses are dried pineapple.
The mouths  and eyes are drawn on with a Shimmering write on gel.


Here  is basic instructions for cake pops:
1 box cake mix (cook as directed on box for 13 X 9 cake)
1 can frosting (16 oz.)any favor that u like i.e chocolate or cream cheese
1 pack of candy melt or chocolate wafers(any favor or color that u want)
METHOD:
After cake is cooked and cooled completely, crumble into large bowl.
Mix thoroughly with the can frosting. U can use the back of a large spoon, but it may be easier to use fingers to mix together. But, it will get  a bit messy.
you may not need the entire can of frosting, so start out by using 1/2 of  the can and add more if you need to.
You can start  to Roll mixture into quarter size balls(can u a spoon or ice cream scope to ensure the size of the ball) and place on wax paper covered cookie sheet or baking tray.
Melt chocolate in the microwave or double boiler.
Dip the tip of your lollipop stick in a little of the melted candy coating/chocolate wafers and insert into the cake balls. 
(insert not more that half)
Place them in the freezer for a little while to firm up.

Once firm, carefully insert the cake ball into the candy coating by holding the lollipop stick and rotating until covered.

Once covered remove and softly tap and rotate until the excess chocolate falls off. 

Don’t tap too hard or the cake ball will fall off, too.Place in a styrofoam block to dry....

keep chilled...served cool..

For the FROSTY THE SNOW MAN CAKE POP u need a bit more patient to do it..
Needed:
1 pack of chocolate wafers in medium size.
1 pack of white chocolate wafers or candy melt in white(i using white chocolate wafers)
some marshmallow,some dried pineapple and a stick of Shimmering write on gel
some cake pop(see above to do the cake pop)


Prepare the hats first.(candy melt or chocolate wafers the white one as a glue) 
Stick the chocolate wafer with the marshmallow together.After finish set aside.
Then for the nose part,cut the dried pineapple to small and long triangle .After finish set aside.
melted the white chocolate wafer ,
Dip the tip of your lollipop stick in a little of the melted candy coating/chocolate wafers and insert into the cake balls.
Once firm, carefully insert the cake ball into the candy coating by holding the lollipop stick and rotating until covered. Once covered remove and softly tap and rotate until the excess chocolate falls off. Don’t tap too hard or the cake ball will fall off, too.Before the chocolate coating hard,place the nose and hat in the right position..And Place in a styrofoam block to dry.Once dry, draw faces with with the shimmering write on gel and allow ink to dry!

DONE.......HOHOHO.....